DIY Computer Microphone

It’s very difficult to get along without a computer microphone, you cannot use voice search without it, you won’t be able to chat with a friend over a video call. However, the built-in microphones are not in all computers, besides, often, they have not very good sensitivity. To solve this problem, you can simply - collect the microphone yourself.


DIY microphone for your computer
The circuit is extremely simple, it contains only two resistors, two capacitors, a transistor and an electret microphone cap. The transistor can be applied to almost any low-power n-p-n structures, for example, KT3102, BC547, BC337. An electret microphone can be obtained, for example, in a broken headset, handset, or else you can buy it in a store of radio components. This element will greatly depend on the sensitivity of the microphone, so it is advisable to take a few and check which one is best.The advantage of this scheme is that it uses phantom power. Those. the sound signal is transmitted through the same wires as the power supply. If you take a voltmeter and measure the voltage at the microphone input of the computer, there will be approximately 3-4 volts. When connecting a microphone circuit, this voltage should sink to the level of 0.6-0.7 volts, so no external power supply will be needed and there will be no extra wires in the workplace.
Do-it-yourself microphone for computer

Schema assembly

The scheme contains a minimum of parts, so you can assemble it by mounting it. But, adhering to traditions, I have etched out a miniature printed circuit board. Tracks can even be drawn with a marker or nail polish. Several photos of the process:
Microphone for a computer with their own hands
Microphone for the computer with their own hands
Download the board: A microphone cap is soldered to one end of the board, and a shielded wire is connected to the other end. Please note that the wire must be with a screen, otherwise the microphone will be terrible to fade.Wire braiding is soldered to the minus, and two internal conductors are connected and soldered to the output of the circuit. Be sure to observe the polarity of the microphone capsule, otherwise the circuit will not work. One of his conclusions goes to a minus, and the second to a plus. Determining the polarity is very simple - you need to ring the findings with the metal case of the capsule. The conclusion that connects to the body is negative.
Microphone for a computer with their own hands
DIY microphone for your computer

Assembling a microphone

A board with soldered parts for ease of use should be placed in a suitable case. Since Since the board has a narrow elongated shape, then an ordinary ballpoint pen can be used as a case. To do this, you need to pull out the writing rod from it and check whether the board is suitable for the width. If the circuit is assembled by mounting, then it can be given any shape and there will be no problems with capacity. In addition to the pen, any elongated object is well suited, be it a marker or a simple plastic tube. The board fits inside, the microphone should stick out slightly from the case. The wire is output from the other side. For reliability, the board along with the wire can be glued inside the case. The tip of the handle needs to be cut so that the hole becomes wider and the sound waves quietly reach the microphone cap.
Microphone for a computer with their own hands
DIY microphone for your computer
At the other end of the wire, solder the jack 3.5 plug to connect to the microphone input of the computer. This completes the computer microphone assembly, you can turn it on and check the sound quality.

Related News:

Knitted cover with decoration on the tablet
Salted mackerel at home
Bow on bandage
5 reasons not to throw out an old sweater
Making a lamb with your own hands