Kacher Brovina and Tesla Transformer
Kacher - a device that generates a high voltage (5000-20000 volts) high frequency. Do not be afraid - you will not be electrocuted. This is not such a current as in the socket - it has a high frequency (up to 250 kHz), and we have a 50 Hz socket. At high frequency, the current passes through the surface of your body. The simplest circuit is shown in Figure 1. In order to assemble this circuit, you will need a minimum of details that can be found on older TVs:
1. 2-a resistor 2. 1 p-n -p junction transistor (it should be powerful and high-frequency, for example kt805. Look in the catalog) 3. 1 Capacitor 4 . Copper wire 0.15 - 0.25 mm (can be purchased at a radio store or unwinding any power transformer )
Buy or unscrew resistors from any radio boards. The capacitor can also be pulled from the boards. The transistor can also be unscrewed from the board - they are usually mounted on radiators. Pay attention to the fact that the transistor had a pnp transition, if there is an npn transition, you need to change the collector and emitter to connect. What can be said about the radiator, it should be big, and if you do not have a large radiator, then install a cooler on the small radiator. We take copper wire from any transformer.
Now proceed to assembly: Take a tube of cardboard and wind the secondary winding to the coil wire (0.15-0, 25) periodically pouring varnish. This is the most painstaking work. The more turns, the better the end result.Now around the secondary winding we make 3-4 turns of a thicker wire (wire, plate) whose thickness (width) should be 1-4 mm. Next, we connect these 2nd windings to the circuit and turn on this device in the network. And what do we see? When you bring a fluorescent lamp to this device, it burns without wires ... We can conduct electricity through the body without hurting any organ, it’s enough to hold your hand to the secondary winding and grab tightly with one hand to one of the contacts of the fluorescent lamp ...
Note: If the device does not work, then turn the primary winding, i.e. The magnetic fields of the windings must match. If you wind one winding clockwise, then the second one should be wound in the same way.
How to install Joomla templateApples with stuffingChicken breast chop in batterFashionable evening dresses, Fall-Winter 2014-2015: photos of fashionable long and short evening dressesHow to revive feelingsKnitted booties-sandals for the babyHow to treat scarlet fever