Laying the site with sandstone

Any dacha plot should have a platform for rest, where you can put a table, a grill, and also to have a place for games or dances. Such a site can be made of sandstone. This option is quite economical, especially if you live in areas where there are sandy quarries. In addition, laying sandstone does not take much time.
Laying site sandstone
So, first you need to prepare the soil for laying the site. To do this, determine the place where the site will be located, dig a small hole about 20 cm in depth at this place. Then fill it with granulation. If you find the roots of trees, then they need to be trimmed. Granulation must be rammed. If this is not done, then over time, some areas of the site may subside, and as a result of this, pits are formed. After you fill the hole with granulation and tamp it down, you can install the curb. To do this, select a sandstone that has at least one straight side.Melon sandstone must be digged along the edges of the site. That is, this you designate the boundaries of the site.
Laying site sandstone
 Laying the platform with sandstone
After you dig up a stone and make a curb, you need to fix it. To do this, knead the solution with one lobe of cement, two lobes of granulation, and two lobes of sand. With this solution, fix the borders at the bottom. In order for the curb to be even you can pull the thread along the level from one edge of the platform to the other. Now you can start laying sandstone of the site itself. Here you especially need to hammer pegs or reinforcement in the four corners in order to pull the fishing line along them. If the ground is large, then approximately every two meters, additional pegs can be hammered along the edges of the ground. From them you need to pull the line, marking the level across and along the diagonals of the site. To do this, you also need a building level. The longer the level, the smoother the platform. Next you need to pick up the sandstone, laying it on the granulation. It is advisable to buy sandstone of a certain thickness.If the stones are different, it will complicate the process of laying. The most suitable for the site will be sandstone 3 cm thick. If the platform is made for parking, then you need a stone not less than 5 cm thick. Laying the stone, you can navigate along the stretched lines.
 Laying the area with sandstone
Laying sandstone grounds
 Laying the platform with sandstone
If the stone is higher, then it should be tapped with a rubber mallet . If the stone is on the contrary below the level, then pour more granulation under it. It is advisable to pour in such a quantity of granulation that you always had to tap a stone. Thus, it will settle down better, and under it there will be no voids. Otherwise, walking on it, he will stagger.
Laying site sandstone
 Laying the platform with sandstone
Laying the area with sandstone
In the process of laying it is also necessary to have a small pickaxe or a hammer. Sometimes it is difficult to choose the required size of sandstone, or a shape that would suit you. Therefore, with a pick or a hammer, you can give the necessary shape to sandstone, chipping away unnecessary parts from it.
Laying site sandstone
 Laying the platform with sandstone
After you have finished laying the sandstone, you must fill the seams between them. This can be done with the same granulation or sand. To do this, scatter granulation or sand on the site, and then using a broom to distribute them around the site. So you fill all the seams. Remove excess sand or granulation. Next, use hoses and water to flush the pad.
Laying site sandstone
Laying the area with sandstone
 Sandstone laying
Another option for filling the seams is to plant moss. This process is complex and time consuming. If you order such work from someone - it will cost a lot. But if you manage to fill all the seams with moss - it will look gorgeous. If you yourself decide to do this work, then you need to go into the forest or planting where moss grows. Using a knife, cut it together with the roots. Then soak it in a bucket of water. After this, you can fill the seams with earth with moss roots. In a few weeks, all seams will be covered in moss. Usually greens are perfectly combined with natural natural stone.
Laying site sandstone
 Laying the ground with sandstone
 Laying the ground with sandstone


Related News:


How to determine the strength of concrete
Gloxinia Crochet
A beautiful box out of an egg box
Baked New Potatoes with Rosemary and Garlic
Braised potatoes with pork ribs
How to sheathe the stairs