The Second Life of the Stool
It so happens that over the years, furniture wears out and loses its appearance. In this article we will try to give a new life and design look to the old stool. We will need materials from the materials: -the glue of PVA, -wool thread, -bistochka, -material, square meter, in our case velor was used. For In order for the composition to be solid, it is desirable to comply with the color range.Take an old stool. It needs to be wiped from dust or grease stains, in which case the glue will lie flat. First step. It is necessary to cut out rectangular pieces of cloth to close the places of convergence of the rails, since it is not convenient to trim out the thread. They are fastened simply enough, on the seamy side are smeared with a thin layer of glue. Get more accurate if the rectangles are a little larger and will slightly stand on the leg.Step two, decorate the legs and crossbars. Apply a thin layer of PVA glue on the entire foot.It is important to observe the proportions, the layer must be such that the thread on one side is fixed, but not soaked, and retains its appearance.Then, starting from the very top, we begin to wind the leg. This is a very painstaking process, you need to try not to leave large gaps and control that all parties are proportional, even. When the whole leg is wrapped, the thread should be cut off and secured with glue from the inside.Similarly so you need to do with all the legs and the crossbeams, then give them a little time to dry. After the process of decorating the legs is completed, proceed to the finishing of the upper part of the stool.Need to cut material that corresponds to the area of the upper part stools,leaving about 2 inches on the sides. The size of the allowance should be 1 cm larger than the height of the seating position.The entire surface is on the wrong side of it with PVA glue. Again, the layer must be thin, it is highly undesirable for the fabric to get wet. You can try to apply glue to the stool, and after that you apply the fabric, but in this case it will not be so firmly stuck.After the surface is processed, the fabric is evenly applied to the stool. The edges are bent and glued to the bottom, not visible to anyone.Corners can be cut when the main plane is already fixed, and carefully cut one over another. In this case, the stool will look complete and pleasing to the eye.After work is completed, it is best to take the stool to the balcony, or to fresh air and allow it to dry completely for about 24 hours. Such an elegant stool will attract a lot of attention and will delight guests with its originality.
10 great ideas: what to put in tartlets. Festive table in the best restaurant
Phalaenopsis Orchid - how to care at home
Making a wicker fence
Vase with pumpkin do-it-yourself
Wonder Women: the hottest heroes of films on comics
Painting on shellac