Spinner from RAM

I know about him, probably, everything from small to large. You can buy almost anywhere. Shops with food stalls. What to say about hypermarkets and supermarkets.
Spinner from RAM
I decided to keep up with the general enthusiasm and created my own design. I had an old motherboard, and on it ... To manufacture a spinner, we need: - RAM, the same one from the old motherboard; - bearing; - Drill bit and drill;- file.
Spinner from RAM
The first step is to drop the chips in the center of our RAM. You can solder without regretting chips. You can first cut off the legs, and then unsolder the remains.
Spinner from RAM
I took out the bearing from the old fan. A diameter of 16 mm. Screw on the screw. Put it in the drill and scrolling washed it in kerosene. After smeared with teflon grease and leftwait for your time.
Spinner from the RAM
In the center of the RAM, I drilled a hole with a 12 mm drill bit and adjusted the file to 16 mm. Pre twisting the two straps with screws. So they acquired stiffness and did not shift during doping.
Spinner from the RAM
When the hole is fitted, take the bearing and gently drive it into the slats. After installing the bearing, fixed the screws with super glue. Spinner is ready. Now you can twist it as you like.


Related News:


New Year's Boot
A favorite gift - a pencil holder with ducklings in love
Felt Crumbling
Autumn greeting card with your own hands
If you have a gap between the wall and the bathroom, then we have found a solution for you
Baby Rocker