Tiene cutter for dust collection system
This is the chopper of Tien (by the name of the inventor, Phil Thien - Phil Thien), whipped up from a 20-liter bucket. in that, unlike the traditional cyclone separator, it does not require a significant height of the structure, and it will take up very little vertical space. The air in it moves on a flat surface from the edge to the center. It works with the same efficiency as the cyclone separator (if not better), does not take up space, and it can be collected literally from cheap materials for 45-90 minutes. Dust collection system
Dust collection system before connecting the slam shutter Bucket.
Cut out part of the 20-liter bucket. Circles.
Use the bucket part to draw circles on a piece of wood. You will need three such circles. One circle is inserted inside the upper part of the bucket, another circle will go inside the lower part, and another one will be outside the lower part. Cut out.
Use the router and milling compasses to cut circles. For this, the jigsaw also works. Circles.
The circle on the left will be set outside the bottom of the carved bucket. There is a groove embedded on it with a router, so that it can be put on the top of another 20-liter bucket. The circle on the right will be installed inside the top of the bucket. Outside below.
Attach the outside bottom with self-tapping screws and silicone. Pipe.
Cut a piece of PVC pipe and round it so that it fits tightly to the side of the cut bucket. Hole in the bucket.
Cut a hole in the bucket so that it matches the diameter of a piece of PVC pipe. Support.
Cut a piece of wood to support the pipe. Attach the pipe to the piece of wood and the tree to the carved bucket. Process with a file.
File a hole in the side of the bucket with a file so that the pipe can easily and smoothly enter it. Use silicone to seal the hole. Inside, top view.
Cut out the hole in the top of the circle for the top inner part. Cut a piece of wood that will stand over the hole and hold the dust collector tube and glue in place. PVC
At the bottom of the upper inner circle, use silicone to close the PVC pipe that will go into the cut bucket. Close.
Screw the upper inner circle onto the screws to the top of the bucket, and then coat it with silicone. Inside the bottom.
Divide the inner bottom circle into three parts. Saw three centimeters from the outside of the two thirds.Screw the circle on the screws into the bottom of the bucket. Foundation.
Make a wooden base on wheels to make it easier to work with the collection system. Bag.
Attach the bag and filter to the base. Support.
Make a support to hold the motor. Exhaust motor.
Attach the motor to the support, bag and filter. Dust bin.
Glue window sealer around the top edge of the dust bucket. Use glue or epoxy for this. Cutter.
Attach the cutter to the motor with pipes. Collect dust.
Raisecutter and put under it a bucket to collect dust. The weight of the cut-off valve and the pressure of compressed air from the pipe themselves will seal the bucket. That's all. Your cutter is ready to go. The incredible simplicity and reliability of the design, in which you yourself can be convinced, looking at the process of its assembly, make it an excellent alternative to the ordinary cyclone separator.
Serena Williams became a momFantastic Knight Cardboard ArmorNew serious novel Di Caprio: the model has an unlucky 13thHow to open GPXQualitative project of a manor for the whole family in the General Project studio based on customer’s sketchesVictorian Interior Style