Two-level flower bed
To your attention I propose a step-by-step process of making a two-level flower bed. Especially it will be useful if there are weaving flowers. So, for making a two-level flowerbed we need the following material:- useless automotive a tire for laying the lower tier (the size to your taste - it's better when it is almost proportional to the upper tier); - a car disc (again, which is no longer useful for a car) - metal pipe lengths up to 1.5 meters and a diameter of up to 6 cm (the thicker the pipe, the stronger and more stable the base of the upper tier.) But it should be remembered that too wide a pipe can significantly reduce the area on the bottom flower bed, so choose the optimal diameter) sledge hammer; - bolts and nuts (2 pcs.); - a metal plate with two holes of 5 cm in length and up to 2 cm in width; - an oil paint of two colors (one shade - for beds, the second shade - for the rack, i.e.tubes); - paint brush; - solvent (as needed). Step-by-step manufacturing process Step No. 1. Choose a place to establish a flower bed on section and immediately put the rubber car tire.
Step # 3. Drive a pipe with a sledgehammer into the middle of the tire with a sledgehammer. In order not to spoil the welding of parts, it is necessary to put a wooden board in the middle of the disc. Step 4. We clean the car tire and disc from dust and dirt. We paint a two-tier bed in two colors. Give dry paint. We put a film on the basis of the disc in order to avoid spilling the soil.Then we fall asleep with the earth and plant flowers.
Suspended ceiling installation
Woolen pompoms for a scarf
Cereal jar decoration